5. Mechanical Properties
5.1. Mechanical Properties at room temperature
Tensile Properties tables 5.1.1/2/3
Hardness 5.1.1/2/3
Shear Strength 5.1.1/2/3
Modulus of Elasticity (tension) see 2.9
Modulus of Rigidity (torsion) see 2.10
5.2. Mechanical Properties at Low Temperature
Tensile Properties no data traced
Impact Properties no data traced
5.3. Mechanical at Elevated Temperature
Short-time Tensile Properties no data traced
Impact properties no data traced
Creep Properties no data traced
Fatigue Strength at Room Temperature
table 5.4.1
5.1. Mechanical Properties at Room Temperature
5.1.1 Typical Tensile Properties and Hardness Values - Metric Units
5.1.2 Typical Tensile Properties and Hardness Values - English Units
5.1.3 Typical Tensile Properties and Hardness Values - American Units
The values shown represent reasonable approximations for general engineering use, taking account of variations in composition and manufacturing procedures. For design purposes, national specifications should be consulted.
For a given temper, individual elongation values may show some variation above or below the typical values indicated.
It will be noted that tables 5.1.1, 5.1.2 and 5.1.3, giving typical tensile properties and hardness values in Metric, English, and American units respectively are not directly comparable. This is because the properties quoted reflect to some extent the metalworking techniques, specification practices, and testing procedures in the countries concerned, and in view of the different sizes of products referred to in these tables. Individual manufacturers of semi-fabricated products, can, however, normally meet the requirements of any national standards.
5.1.1 Typical Tensile Properties and Hardness Values - Metric Units
5.1.2 Typical Tensile Properties and Hardness Values - English Units
Tensile properties and hardness values in English units are omitted from this data sheet, since alloys within the composition range concerned are not normally produced by British manufacturers.
5.1.3 Typical Tensile Properties and Hardness Values - American Units
5.2. Mechanical Properties at Low Temperature
5.2.1 Tensile Properties - Impact Properties
At the date of publication of this sheet, no data relating to this material have been traced.
5.3. Mechanical Properties at Elevated Temperature
5.3.1 Short-Time Tensile Properties - Impact Properties
5.3.2 Creep Properties
5.3.1 Short-time Tensile Properties - Impact Properties
At the date of publication of this sheet, no data relating to this material have been traced.
5.3.2 Creep Properties
At the date of publication of this sheet, no data relating to this material have been traced.
